Directions for Use

For Use On Hay

Spray PRESERVOR on the hay as it is fed into the baler using the correct application rate indicated on the charts. 

Treat rained on hay at one level higher than current moisture. Don’t stack dry hay on top of high moisture hay.

Use a reliable moisture tester to determine moisture content of the hay in the windrow before applying PRESERVOR. Follow applicator instructions to calculate baling rate and set sprayer calibration. Use three nozzles to achieve complete coverage.

Stack hay to provide maximum air movement between bales. Untreated dry hay should not be stored in contact with PRESERVOR treated hay. 

Small Bales:
Maximum moisture 26%. If hay is rained on, treat as stem moisture.

Large Bales:
Maximum moisture 23%. 

For Use On TMR

Spray PRESERVOR™ on crop at chopper or blower intake using the correct application rate indicated below. Note that TMR usage rate depends on average daily air temperatures. Use rates should increase as air temperature rises.

2-4 lbs per ton of Total Mixed Ration  

For Use On Baleage

Spray PRESERVOR™ on the hay as it is fed into the baler using the application rate indicated below: 

2-4 lbs per ton (optimum baleage moisture range 48-56%) 

PRESERVOR™ helps reduce harmful microbial activity which causes feed heating and degradation. Also assists in minimizing Dry Matter intake slumps, which in turn helps reduce milk flow and component slumps during times of high Temperature Heat Index. 

For Use On Silage and Haylage

Spray PRESERVOR™ on crop at chopper or blower intake using the chart provided.

For Use On High Moisture Grains

Spray PRESERVOR™ using the correct application rate indicated on the chart. For whole corn, increase rate 2x-3x.

Additional Usage Information

Any residual chemical of any kind (in any storage or application apparatus) should be flushed completely, and the equipment cleaned thoroughly with water, eliminating residue of any kind.

All application equipment should be in good working order so that good coverage is obtained. All spray nozzle openings should be clean and free of obstruction and should be placed to ensure thorough coverage.

Stack hay to provide maximum air movement between bales. Untreated dry hay should not be stored in contact with PRESERVOR™ treated hay. Baled hay treated with PRESERVOR™ should be in a protected, but well ventilated, area. Stack hay to provide maximum air movement between bales. Untreated dry hay should not be stored in contact with PRESERVOR™ treated hay.

Application of PRESERVOR™ is NOT recommended if the hay moisture level exceeds 26 percent. Keep PRESERVOR™ from freezing.